Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
4 plates
Open in Bambu Studio
Boost
3
8
0
1
4
1
Released
Bill of Materials
Description
Hey MakerWorld! This is my debut 3D model – a super-compact, 3D-printable smart lamp powered by an ESP32-C3. One capacitive touch button = ON/OFF.
Features:
- ESP32-C3 with Wi-Fi & Bluetooth
- 6-8x WS2812B LEDs – use a module or cut strip
- Single touch = toggle lamp
- Assembly with glue (super glue & hot glue recommended)
- HomeKit Support
Software:
- Ready-to-flash firmware on GitHub
- Arduino IDE setup – full instructions in repo
⚠️ First Model – Known Issues & Tips:
- Gap between diffuser and top cap – ~0.3 mm tolerance; seal with glue or add a thin foam strip
- Print settings matter! I’m still dialing in my profile – please double-check
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)