Search models, users, collections, and posts
Method 502 Center Cap Drill Guide
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
1
2
0
0
2
0
Released
Description
This was made to use as a drill guide for a Method 502 wheel that was missing the drilled and tapped holes for the center cap. The pilot is 67.1mm and worked well if the wheel had powder coat in the bore, if it is loose you can use a wrap or two of painters tape to snug it up. Also used two sided tape on the pilot bushing side to hold the guide in place.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)