Search models, users, collections, and posts
DIY Sequential shifter
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
6.7 h
1 plate
Open in Bambu Studio
Boost
0
4
0
0
0
0
Released
Description
Sequential shifter for driving sim, requires: Arduino Leonardo, 8mm all-thread (cut to size), M8 nuts, M8 dome nut, 608rs bearings, M3 screws, expansion springs, M3 inserts, TIAIHUA Microswitch and 22 awg wire.
Wiring:
Microswitch 1 com - Arduino GND
Microswitch 1 NO - Arduino pin 2
Microswitch 2 com - Arduino GND
Microswitch 2 NO - Arduino pin 3
Programming: Assign upshift as E and downshift as Q, code
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)