Search models, users, collections, and posts
Recommendation
Creator’s Club
Creators & Fans
Show Your Make
Off Topic
Post Details
#PrintClinic Help! I've tried this print twice now - re-sliced it in between. Same thing. Puts down the first layer just fine, and then - it goes crazy and starts digging up the PLA it laid down. Please help. (I'm running bed leveling now, but just ran it the other day)
This is not unstuck. It's been torn apart by the nozzle.
Share
0
3
0
Comment (3)
@waylaidwanderer : Welcome to the Print Clinic! While it feels like the nozzle is actively digging into the print, this is almost always a stealthy bed adhesion issue. Even if the print seems firmly attached, if the edges curl up even a fraction of a millimeter due to cooling shrink, the nozzle will physically collide with the plastic on the next pass and tear it apart. When was the last time you washed the build plate with warm water and dish soap?
0
Reply
@Aaron987B : Just clarifying is the issue still occurring after you turned on bed leveling? I would suggest bed leveling and a full calibration.
The poster has replied
0
Reply
@cynsight : Yes, it did it after leveling. Running full calibration now. Thank you!
1
Reply
No more data
Trend
PrintClinic
1
Renew MakerWorld
2.4 k
2
Revivemakerworld
1.7 k
3
Stopnsfw
1.6 k
4
the Great Benchy Nations
1.6 k
5
Questions
817
6
Newmodel
595
7
Contests
490
8
Sharing Makes
369
9
Littleguymodels
318