Remixed the original to fit smaller wooden dowels of 0.5 inch or 12.7mm diameter. Printed with PETG and it turned out strong and works great!.

Seed starter pods for a hydroponic herb growing system. This is a general size, should fit all devices.

Remixed the original to make it smaller and made a new water draining tray with a voronoi pattern. The tray is also flat so you do not need supports like the original hexagon one that is curved.

I made this locket or earring, depending on how large you print it for my gf. Now you can have it too! Paint the center logo red or use multicolour.

This model is for a swing set leg that broke. Printed with PETG and 90% infill, its holding well under load. You can see the original broken part in the picture.