There's a slab of dead space hiding under your Model Y Juniper's front seat right now — and it's doing absolutely nothing for you. This low-profile storage tray fixes that, turning wasted volume into a legit stash spot for cables, tools, sunglasses, snacks, whatever you don't want rattling around your cabin.It's built to disappear. Rounded, factory-style lines mean it looks like it came from the factory floor, not bolted on as an afterthought — and it's engineered to clear seat rails, wiring, and vents so nothing binds up when you slide the seat.Why this one's worth printingReal capacity — a wide-open compartment, no wasted space on dividers you don't needSlides in clean — low-profile fit, no clearance headachesBuilt for your printer — splits into two pieces so it fits standard Bambu Lab build plates, both parts in one print profileNo guesswork — support settings are already dialed in and testedThe numbersLength: 13.6"Width: 5.9"Height: 3.8"Print it rightPETG only for this one — it's the material that actually survives a hot, parked car. PLA can get you a test fit, but it'll soften and warp once the interior heats up, so don't trust it for the final piece. Before you drive around with it installed, double-check it's not fouling seat rails, wiring, or vents.One honest note: this is an independent, aftermarket design — not made, approved, or backed by Tesla. Brand names are here purely to tell you what it fits.Print one, love it? Drop a like, grab the download, and show off the finished piece. Happy printing. https://makerworld.com/en/models/3065930-tesla-model-y-juniper-under-seat-storage-tray#profileId-3450918