Works perfectly. I regret not printing more of them in the same go. Printed two which was a perfect fit. Will print additional ones soon. Thanks for the great model. Printed using X1C with 0.4mm Nozzle using Bambu - PLA Basic on Textured PEI plate.

The model fits perfectly to the Bambu filament spool, the only reason for not providing 5 stars is due to the hole is barely holding on to the filament. So, super tight tolerances or due to the small arc on the model. It works, I just thought it would secure the filament tight.

Thanks for the nice model. I was able to use the supplied Basic PLA from Bambu with the X1C. My first large print was a success thanks to you

Works well with a tight fit. Ran out of green filament mid-way, but the white and green was a good match. Printed with X1C with 0.4mm nozzle using Bambu - PLA Basic on Textured PEI Plate. Thanks for a good model.

Works and fit perfectly to a Bambo filament spools. Printed with X1C with 0.4mm nozzle with Bambu - Basic PLA on Textured PEI plate.

Nice model, easy to print and assemble with glue.

Thanks for the model! Printed without issues, very little cleanup. But be careful when removing the part from the build plate. I waited until it was completely cooled down, then used a spatula all around the part to avoid any potential breakage at the threads. printed with X1C with Bambo - PLA Basic on textured PEI using the 0.4mm nozzle. again, thanks for the model.

Perfect print profile for X1C with Bambi PLA Basic. Thanks!