A fun little model, though takes a while to print with all the filament changes — as suggested, I printed several at once for improved efficiency. I added an extra pair of legs to make it a bit more bee-like, and reduced the layer thickness to increase detail a little. Printed in the PETG I had to hand, so had to replace yellow with light brown (not so good) and white with translucent (looks good for the wings).

Printed in PETG, first at original scale, but that was too small for most of my needs, so this one was scaled to 200%, with 50% infill for strength. It is big and chunky, but effective!

Printed just fine in three colours of PETG on my Bambu Mini. Nice job!

Very happy with print in PETG. I found that pouring boiling water from a kettle over green parts was a good way to get them to bend and droop naturally.

best fidget spinner I’ve seen — love the non-circular gearing. worked perfectly right off the plate.

Printed perfectly in PETG. My first modest experiment in multi-coloured printing involved painting his toenails!