Printed in Bambu Black and Green PLA on my H2S. The first base (on the right) had holes that were too small and did not fit the tube. You can also see this weird ring around one of the two holes that I also see in some other peoples makes here. The second base I increated the X-Y Hole Compensation to 0.11mm and it printed fine. As others have said, cuts PTFE tube like butter.

My orbloop turned out great! I used Bambu Purple PLA, together with Bambu Green and Matte Red. Just what happened to be loaded in the printed at the time. Quick easy print.

I've been busy printing these in Bambu Silver ABS. Printed at least a dozen of them by now. Picked ABS due to the heat resistance. Also did a few in PETG before my ABS spools showed up. All prints flawless.

The moel printed great. I used some old AmazonBasics PETG for the grey and black block pieces. The rotar was printed in bambu silver silk PLA, and the gears were printed in bambu gold silk PLA. I swapped the wires on the motor to make it turn in the right direction (liked that better than flipping the gear). No squeaking, no binding, everything spins fine. The only issue is a "clunk" as the rotor turns and the center of gravity shifts. There's a lot of play in the plastic gears and shaft (this is plastic, after all!) and I did wrap a little bit of kapton tape around the crankshaft where it meets the front gear and where the hub in the center meets the rotor. Might try adding some silicone grease as well. Good print.