Search models, users, collections, and posts
Bio
3D printing hobbiest looking for fun functional prints that do something.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 282 different models
Pioneer Maker
Print successful 267 different models and 1,134 hours
fit my recteq probes great! I added 10 x 2 magnets to the holes that were already there to stick to my fridge. nice press fit
Share
1
0
0
Share
1
0
0
printed well, and holds my lids well. A little tight but it works!
Share
0
0
0
these printed well, the magnets aren’t quite strong enough to hold up most items u fortunately
Share
0
0
0
this printed well. I like it, but the probe sticks out a bit awkwardly, and the slide together parts inside easily without glue. I’m using it for some of my old probes!
Share
0
0
0
this holds a few of each type of my meds, great for travel!
Share
0
0
0
Share
0
0
0
great design! less filament then other designs, and you can adjust the height for your straws. a little too thick for my cabinets if the straws are full though.
Share
0
0
0
I recently purchased a 100 pack of nasal strips, but was frustrated that the packs were frustrating to grab at night, and I had nowhere to put the trash when I woke up in the morning. I didn't immediately find something that would work already on maker world, so I decided to make my own! I'm hoping it works well at my bedside and for travel if necessary (even though it's kind of large...).
Nasal Strip Dispenser and disposal
10
36
Share
0
0
0
No more data