Perfect.

Useful. I don't have immediate issues with this design.

Perfect.

Adequate. The middle hole is maybe a bit too large; it easily flips the phone if you don't center it correctly whilst deposing it.

Works great. The print is actually very smooth. I would have liked larger notches though as not all my cables would fit --- and some were downright tight as you can see from the image, floating above the plane. I might upscale my next print for them to fit.

Well done.

Well done.

Will definitely be useful. My print messed up the finish on the last layer for some reason.

It's also useful for storing my extra printer plates and some extra trinkets around that space.

Spoooky!

The basic setup. I still don't know what the red connectors are supposed to do though.

Solid.

(Sorry for the repeat. This is my official rating.) A nice build. The traversal bar could not be put from the outside, like the instructions say, it's better to line it up on the inside before attaching the rear support.

I'm never buying another spooled filament again!

Decent. My first AMS and launched from Bambu Handy.

Printed beautifully.

Classic. Mine is saved in permanence in my SD card for each new color I bring in.

The printing was pretty straightforward. I made the cylinder out of transparent PETG thinking I would see the water level in the container. But I can only see a faint line, very difficult to see with proper backlighting.

Very cute. Left arm support snapped during printing so the arm feels incomplete. May need to strengthen it.

The print went smoothly. And its well done.