Printed nicely in Sunlu PETG. Nor as bright as I would like, but that is my fault for using a USB powered led strip, new 24v strip due in tomorrow. 10mm strips are hard to find, but 8mm works nicely with good adhesive.

Printed nice, but they are just a touch loose, the weight of the magnets cause them to side down without pressure.

Printed nicely and will do what it is intended for

Printed great in petg

Great design. I added magnets in the base to hold minis in place better :)

Really nice job, like the various inserts for varying brush sizes

Prints really nice with the 0.2 nozzle, but need to adjust z distance for supports

Nice print, but a heck of a time removing supports

Awesome job, Printed beautifully and only took a couple minutes to find the right orientation for assembly. Really like that it support a wide range of base sizes.

Really like this display. I like to use 10x2mm magnets in my mini bases, so I modified the floor of this so I can embed 10x3mm underneath, this helps keep the minis more stable and prevents shifting around :)

Tough time getting the supports to stay on the bed, but the models are nice

Great print. Wand is a dad thin, I broke it while removing supports :(

Printed perfectly

Beautiful print

Really like these containers

Exactly what I needed and printed perfectly.

Really like this little box. A bit on the small side, but closes securely and prints nicely.

Printed nicely

Prints beautifully in PETG

Good print