The model is great and appealing. Could you kindly provide 6.5" model as well? I printed the 6" and it was a tiny bit too small for my pot

I really like the model, though because of my extension cord has walls with a radius, it is held not as tight as I expected - but that obviously is a problem of the cord :)

we had a lot of fun throwing it, but it broke too fast... though it was PLA, so no complaints

works well, no probs

soooooo cooool! a little bit too loose and wobbly, but tightening a nut mostly solves the problem. a really great stuff, printed one for myself and one for my wife

well, it holds my 4 kg laptop, so I'm satisfied!

halves connection is too loose and doesn't hold at all. a little bit more tight connection wouldn't hurt IMO

a really cute guy :) tried with 0.12mm layer as well as 0.16mm and 0.2mm - all is good :)

this uses quite a lot of material for flush and waste, but the result is cool. I checked what it would take to print 7 models in a single run, and just am not ready to spend 35 h on it :)

oh boy, what a thing! didn't try the propeller outside yet, though, but spinner performance is outstanding

a really fun toy for me and kids! used a gum of around 50mm and needed to fold it, but it's working smoothly <3

fulfills the purpose well; could be a little more tight, but that's not a problem for me