Great file that printed perfectly.

Super helpful for organizing filament

Another great design, thanks!

I'm blown away by this project, Thanks for the design time you invested! There was a possible support problem with the bottom of the two back sections where the filament looks like it is printing in the air so it was a bit rough. Sandpaper smoothed it out so I'm not concerned.

Nice work on this! Only one part had a tiny issue. The divider lifted slightly on one side of the base, print finished fine. As mentioned, a brim would help this.

The honeycomb face on this pront is fantastic. XBOX controller fits perfectly. I printed some 10mm x 3mm circles out of TPU for the 6 foot inserts.

Great little print. These are quite small when using the default size but my kids love them for their books.