works great!

Overall it LOOKS amazing.... but next time I print it, I think I will try to modify it to increase the size a bit. The main bins are deep enough but a bit narrow... (currently not worth the bulk of the print for the limited storage size at the current print size)... Also, while the bottom compartments look cute, the tiny flat bins are too small for almost anything. However, the design overall looks very high end, and nicer than almost any desk organizer that you could purchase in a store!

Perfect size for both my thick west-elm headboard, AND for the railing on my glass shower door so that I can use to dry the hose over my bathtub after cleaning the tube.

This is such a fun, easy, silly little print... For silly fun, I printed up a few batches of them, used acrylic paint markers to color in varying degrees of clean to dirty "water" in each bowl, and now every time I use a facility out of my house (restaurants, bars, gas stations, frined's houses), I end up leaving one of these models behind on the sink for the next person to find. Just a silly way to spread some joy!

Works great! holding a mop right now!

I was a little worried when I first printed it because it looked a little too small for my 100 ft cord. But it turned out to be the perfect size and awesome space-saver for my unruly cord!

I made it a bit bigger and then my print seemed to fail on the leg a few times, but I kept adding supports until it finally worked out. but the original size worked out perfectly on the first try. Love this little chair!

Silly little print, but you'll find yourself playing with it again and again!

This was my first thing I've ever printed in TPU (and it wasn't even Bambu Lab TPU, so I was expecting the settings to be off... but it turned out pretty much perfect!

Absolutely love the extra space I've reclaimed on my desk from this little print!

Perfect little print!

Looks GREAT! I added some blue (since there is water between the bridge "bumper") and the bridge itself. Plus I used lighter and darker grey on the sidewalks and road (as it appears on the bridge itself per a google map image from above)... Next will be some tiny cars for the road!

I love this little thing, but FYI, the front feet seem too far back (making the center of gravity cause the thing to fall forward when you pull open a drawer with too much stufff, so I ended up designing some TPU "shoes" for the feet that actually reach toward the front of the model. I'd share my design, but it's a pretty basic design I did on tinkered, and not very polished.

Awesome print - looks great! I tilted the base on its side (using the cord stick as a kick-stand) which made the top look a lot nicer.

Cute little guys but be careful when removing or the feet can break off easily!

Looks awesome - I ended up printing super tiny and detailed versions with the .2mm nozzle and I colored the square base black (so a total of 3 colors) and it looked SOOOO good!