Good for my Lab Rax

Printing is fine, unfortunately the parametric change will not change the size of the hinges and closure, only the size of the box.

It works

Nice model

I somehow forgot to rate it.

Print and change text without problems.

I was unable to print everything from the first board at once, it was impossible to keep it on the base, although this is obviously a fault of the material I used (ABS), I managed to do it in parts.

I printed out the version on the M6 ​​I had available.

Printed from ABS. I'll mount it tomorrow and see.

No lid yet, I need to test it.

Printed from Geetech material.

Printed with 0.12 layer.

Printed with a layer thickness of 0.12.

Good model, a leg broke off on the label, but that may be due to the type of material. The box for 20 pieces is small, however. I store my collection bullets in them and 20 pieces is really not enough. I would like, and not only me, a box for more pieces, ideally stackable for 7.62 x 39.

Printing without problems, we'll see how it works.

Nice model, printed without problems.

Nice model, printing ok, it will need some postprocessing.

Model okay, print okay. I also printed out enlarged versions for use with a tablet. There, the moving parts showed a lot of freedom. The model is not very suitable for mere enlargement.

Model okay, print okay. Printed from PLA.