Printed in PETG and works really great! Thank you for sharing!

Great design, thank you for sharing! I "painted" a few layers with TPU, both on the interfaces with the objects and on the case "seal" to act as a gasket. Worked out great and provides a very good seal now when closed.

As expected. Perfect print.

As expected. Perfect print.

Really cool and great sound on such a quick and easy print! Thank you so much for sharing it! Unexpectedly I got some warping with it, but I'm sure that is something on my end as the performance of my H2D for PLA overall is quite poor...

Really nice design and it should have printed fine. Hence the 5 star rating, cause I'm convinced that the issues I got in my print are related to something on my side. Not sure what it could be though, maybe material, but overall I've been quite disappointed with the performance of my H2D for PLA prints... Thank you so much for sharing this!

Nice design, I quite like it. As improvement suggestions I would place, by default, the chassis on its side in the baseplate. I would also make the wheel shafts slightly thicker and increase the cones on the ends, so that they don't slide so much to the sides. Also I believe the gaps between parts that are supposed to mate (wheels) should be tighter, as in some cases even with glue it's hard to get a good bond, just because there's too much slack. Other than that really appreciate it! Thank you for sharing it!

Really nice design and turned out great even in PETG. Thank you for sharing!

printed in ABS. great fit!