amazing, but I can’t understand why the designer deleted the H2D from this profile

good

awesome

awesome

awesome print! use hairspray to stick the print onto the build plate

awesome

awesome

supports came off well

really good, I had to print 3 of these to get rid of problems, but every time I did, I saw a difference in quality. I just wish there was a way it could avoid hitting the prime line at the beginning.

amazing! 🤩 takes a little bit to find out how they clip in, but after that it’s perfect 👌

printed in PLA and it worked with no issues.

it puts a little glare on the camera, but other wise ok 👍

DONT PRINT WITH SILK FILAMENT! the staffs break very easily, mine even broke of when printing. overall a really good design though!

amazing 🤩

Amazing!! Just wish the tpu for ams stuck to the pla…

Please make an AMS profile I’m begging you 🙏🙏🙏🙏🙏

if you have a P1S, then go to a slicer, because it will print a 90%. if it prints at 90%, then it will not fit a quarter in the top

the top was kind of grey, but overall a good print