Search models, users, collections, and posts
Bio
Printing & simple modeling.
Achievements
Pioneer Maker
Print successful 158 different models and 1,297 hours
MakerWorld Guardian
This badge has expired
Printed beautifully, even scaled down a little bit on the z axis :)
Share
0
0
0
Fits great and haven’t had a stray string of filament end up on my plate yet since the install two days ago, when it was a daily occurrence. Printed with PETG and this lil thing is great.
Share
0
0
0
Super cute! I did have to downsize the inner shell a little bit since the first try wouldn't pop fully open inside, but once it worked, it worked.
Share
0
0
0
Share
0
0
0
Share
0
0
0
Works perfectly for my cuttings :) I glued the handle in because it would pop back out pretty easily, but a little glue is an easy enough fix so it doesn't change my opinion on this being a great print.
Share
0
0
0
I made the pot a bit bigger to fit my plant, but love this model and it turned out very nicely!
Share
0
0
0
Very lovely! Scaled it up to hold tea bags as a gift and it was very well-liked. Lid fits perfectly.
Share
0
0
0
This turned out super cute! I made a few modifications- the lid is about 2mm too short to sit on the base, so I extended that a bit, and added a center piece in the lid that fits into the center rod to add some stability to the lid as well. The other mod was just for aesthetics, I flattened the lettering so I could use the holo plate! Love how it turned out, and overall very nice print once you either shorten the rod or extend the lid a bit!
Share
0
0
0
This turned out so cute! I scaled up by quite a bit as my sage needed some more room to spread out, and everything still fits great. It is stable enough without glue, as well. The only issue I had (which very well may be due to my scaling, so not taking any stars away for something that could easily be my own fault) was that for the legs, there would be pretty large floating regions around the second to fourth layers to get that wood texture- too close to the plate for supports, but far enough away that it would not lay on the plate and I'd end up with little pieces everywhere. I fixed this by dropping the legs about 3 layers below the build plate, and that got it good enough to continue with the full print. Totally worth the troubleshooting for such a beautiful pot, though!
Share
0
0
0