the bottoms came out a little more square than expected. would have settled for more supports instead of that but they came out great otherwise.

Printed in ABS, came out beautifully.

So many filament changes but the result is very cute.

Everyone that has played with it loved the fidget itself and then is incredible impressed it printed in place.

Exactly what I needed, also not limited to LittleGiant brand, most of these pumps are a standard size.

Supports are a bit hard to remove but much less wasteful than the original profile

works perfectly and was exactly what I needed.

super fast as described but definitely can tell how light weight they are.

had some bed adhesion issues but I’m pretty sure that was on me and a not clean plate.

Printed beautifully and doesn’t use a ton of filament like other models

I can’t get over how good this print and design are.

There were some odd layer separation issues and it’s a little rough in the cable channel. That said you can’t really see any of that when it’s upright so it still looks great.

Base and some of the inside layer came off when removing the supports. Still looks great so not worth reprinting but definitely didn’t go 100% as intended.

The print itself is great, the scoop handle attaches at the opposite end of most scoops which is a bit odd but isn’t an issue with function.

I noticed that if I split the print to two plates it was going to be much faster. Turned out great!