I need to keep myself accountable, so I am making this post in order to stop procrastinating. I will be out until May 25th. upon return, I will start working in the following requests: - Fan Blade Gemerator 🌬️ - Euro & Pound signa for letter boards. 💶💷 - Cover for glass rinser 🚿 - Capsulator Customizable 💊 ... probably in that order :)

Sharing my emergency replacement pads for Silberschnitt glass cutting running pliers! I designed these replacement pads because I was in the middle of a stained glass project and the pads on my pliers gave out. I needed a fix ASAP and couldn't wait for shipping. (They are about $10 on Amazon, so they are pretty affordable)

I designed a parameterized stator for a personal project. I tested it with 120mm ARCTIC PC fans, using 7 curved vanes at a 30° twist to hopefully be able to put several in series for a solder extractor project I had in mind! You can customize: - fan size - number of vanes/fins - amount of twist - length of stator - screw hole sizes - dead zone area

I designed this tape dispenser caddy because the ones I found online were too expensive and didn't work for my needs (too many slots I didn't use, difficult to feed tape, etc). I had a lot of fun designing this in OpenSCAD because I had to use trigonometry to calculate where to put the curved edges for the tape outlets so the the tape feeds out smoothly without snagging. It’s fully customizable and ambidextrous, so it fits any setup. I hope this makes your stained glass work a little easier!

I designed this separator originally to hold stained glass sheets securely on my shelves. It turns out this design works perfectly for comic books, magazines, and manga as well! 😮(Edited)

Showcasing a print I made for my mom 😊. She's a chemist, and she needed a drying rack for her glass vials. The drying racks that are commercially sold don't really fit her lab needs, so I designed one for her requirements!

This finger support started as a gift idea for my wife and her friends for their next girls night! The designer from the other model challenged me to come up with a model that uses no supports. So, here it is after a few minutes of fiddling around!

My Annual Report