This was the first laser cut project I did together with my 15yo son. It cut a lot faster than I expected and turned out great. Awesome first project for us to sink our teeth into. Thanks for such a great model!

Sits within the hole and doesn't wiggle around. Great design! Printed with Bambu Labs PLA Basic Bambu Green.

This bowl turned out really well. I increased the size to 125% and it's really large! Holds almost a full 24oz bag of Pistachios. Turning the inside basket is really easy and holds a great amount of shells. The slots to allow crap to fall through is genius. Solid design! Personal preference... I don't like the white oak primary color on the lid and will probably reprint it using PLA Wood Black Walnut. Do not take this as a criticism of the design or designer. This is my own personal preference and putting it here as others might want to think about doing a different color too. Printed with Bambu Labs PLA Wood White Oak and Bambu Labs PLA Matte Grass Green.

This design is really good. Makes having to place all these gridfinity magnets easy on the fingers. Pay special attention to the polarity indicated in within the instructions. The designers tip to print two different colors for each polarity is genius. I didn't have any rubberbands so I am running them without until they arrive next week. I don't see this causing any issues. Sometimes when moving the next magnet to the tip it will get hung up on the corner. Nothing I can't fix with a simple finger bump. If it keeps happening I plan on taking some sandpaper to round it out a little more. Printed with; Bambu Lab PLA Matte Charcoal, Bambu Lab PLA Basic Red, Bambu Lab PLA Basic Blue.

Wow, I am blown away. This turned out great! I did enable supports and regret it... they were a PAIN to take off since they went inside the hole in each loop. That was my fault. I printed it using 4 different AMOLEN PLA Shiny Gradient Filaments; Black Red, Red Gold, Blue Silver, and Galaxy.