Dr.Mog Rc

cover

20240910_102041.jpg

20240911_221045.jpg

20240911_221051.jpg

20240911_221107.jpg

20240911_221131.jpg

plate_1.png

plate_2.png

plate_3.png

2024-12-01_14b8cf044710d.jpg

0.2mm layer, 4 walls, 15% infill

Seats with cutout for cabin floor

Rear cover short (slight opening for wires)

Rear cover high (fully covered)

plate_4.png

El_Twin

20250306_085942.jpg

20250305_203340.jpg

20250305_203401.jpg

20250306_090251.jpg

20250306_221144.jpg

20250306_221151.jpg

20250306_221616.jpg

20250306_221718.jpg

20250306_221748.jpg

20250306_221803.jpg

20250313_072530.jpg

I remixed the Armadillo footwell from <a target="_blank" rel="noopener noreferrer ugc" href="https://makerworld.com/en/@feldmuetzchen">Feldmützchen</a> and extended it to reach the back. Print it as in the profile for strength. I did modify it for servo clearance but with the vast amount of servos out there hopefully there won&#39;t be clearance issues. I would suggest to print it with PETG at least, as high temperatures could deform some PLA filaments.&nbsp;I added a rear cover which can be glued to cover up the rear cabin opening (with a short version if you need to pass cables). This could be improved to be able to mount it with hex screws to the cabin floor.&nbsp;I scaled up the the seats from <a target="_blank" rel="noopener noreferrer ugc" href="https://makerworld.com/en/@Dr.Mog">Dr.Mog Rc</a> to fit my 6&#34; driver figure. The seats should be printed at .16mm layer height for more details and 10% infill to keep low weight. I had issues with mesh Boolean so there is a negative box to cut out and fit in the cabin floor.&nbsp;Enjoy!

Print Profile(2)

Description

Comment & Rating (52)

License

Related Models

HX interior

Print Profile(2)

Description

Comment & Rating (52)

License

Related Models