Falcon 780 Project
Print Profile(1)
Description
Main wing carbon rod 650mm long, 5mm diameter
Tailplane carbon rod 200mm long, 3mm diameter
Wing fasteners M6 nylon nuts, 40mm long, 2 pieces with M6 nylon nuts
Pushrod 1mm steel wire 150mm, 3 pieces
Servos 3x 9G PTK servos
Recommended Fengyun 2006 motors 1506/1806/2006/2205/2207 motors, 2 pieces, KV value 1800~2500
Propeller Ganfeng 5-inch 2-blade prop, 1 pair
ESC 2x 15~30A brushless ESC (no BEC required)
Battery 3S or 4S 1P 18650/21700
Receiver and GPS are for Qidian Communication, cheap and good
Flight controller Feidan Air H743
Print infill: Wing - gyroid; Fuselage - gyroid/adaptive cubic; 3% infill rate; 1 perimeter; 3 top layers, 3 bottom layers
Motor mount recommended 30% infill rate, 3 perimeters, 4 top layers, 3 bottom layers
Center of gravity: At the main wing carbon rod, *slightly nose heavy is recommended
Empty print weight should be controlled below 300g. Recommended PLA Aero filament
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)