Eyelander
Print Profile(1)
Bill of Materials
Description
It's the Eyelander! Not much special there, its just a totally normal not possessed sword!
Anyways, this is slightly out of the usual. Why? Because I am recommending the need for a 6mm Rod with the length of 1 meter. This is for strenght and to make sure the sword doesnt break. Anything that is 6mm in diameter and 1 meter long will suffice.
YOU WILL NEED TO CUT IT DOWN TO 92CM!!!
Besides the requisite it is a fairly quick print. The main part of the hilt is on a risky angle so be sure to apply all tactics for good adhesion to prevent the print from falling over. Same goes for the blade pieces. (I do not want to see another comment or rating saying"Bad bed adhesion" or something similair. This is user error, not fault of the model. Clean your buildplate and apply glue.)
One small note on assembly, the leather strap on the bottom of the blade needs the blade to be inserted from below. (rather easy to figure this out, but id rather notify before hand)
Membership
Want to support me directly?
Boost Me (for free)
Or you can do so through boosts!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)