Model rocket

This is a 3D printable model rocket. When you print it, you will get two guides, a nose cone piece and ring, a shock cord attachment, and a fin can. This all fits a 33.7mm outer diameter, and a 32.1mm inner diameter body tube about 1.5 ft tall. To assemble, slide the fin can onto one side of the tube with glue. After this step slide the shock cord holder with a shock cord tied on into the tube about 6 in deep (Rubber bands can work as shock cords). after this, glue the small loop into the nose cone and wait until everything is dry. after this securely tie the shock cords loose end onto the nosecone. once you are at this step, you will need to glue the launch guides onto the side in a straight line as not to be blocked by a fin. To put a motor in you can use an A, B, or C class motor. Rap the motor in scotch tape until it slides into the hole in the back of the rocket and stays firmly without falling out (make sure it resists being pulls out a bit as well.)