Search models, users, collections, and posts
TPlink access Point
IP Report
Print Profile(1)
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
3
19
0
0
10
4
Released
Description
The Access Point mount I downloaded and printed had misaligned holes.
Please verify you are using the bracket shown in the photo.
It was made with tapped holes to accommodate M4 bolts.
If possible, please tap the holes for use.
A 10mm x 2mm magnetic hole was created in the base.
It was printed in ABS, but any material should work fine.
The mount was created by 3D scanning, so the screw holes will match 100%.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)