Voltmeter with Switch
Print Profile(1)
Description
The voltmeter with switch I designed originated from a netizen's request to add a power display function to my electric tool multi-battery series-parallel power outlet, so this product was released The required materials are
1: 0.28 voltmeter
2: 5.8*5.8 self-locking switch
3: M2*4 self-tapping screws 2 pieces, M2*8 self-tapping screw 1 piece
See the picture below
See the finished product
Install it on my electric tool battery four or six cell series-parallel power outlet as shown
Pass the voltage measuring wire through the wiring hole on the connecting rod and into the wiring slot Then glue the voltmeter head onto the connecting rod
If it's a two-battery series-parallel connection, see the picture below
Drill a small hole in one end of the wiring slot (the end without an XT60 installed), insert the voltmeter's measuring wire, and then secure it with glue
The above is just one application, and it should be applicable in many places Your support is greatly appreciated thank you very much
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)