Large Smooth Mousepad

Large Smooth Mousepad

This is a large mousepad designed for smooth, precise mouse movements. With its generous size and clean surface finish, it is well suited for gaming as well as productivity setups.

Key Features

• Large size: 280 × 260 × 3 mm (adjustable)
  • Provides plenty of room for wide mouse movements.
  • Takes about 3.5 hours to print on the H2C with the Border 
• Very smooth surface
  • Optimized for low friction, enabling fast, controlled, and consistent mouse movements with excellent responsiveness.
• Rounded edges
  • Soft, rounded edges improve comfort and prevent sharp transitions on the wrist and forearm.
• Customizable accent border
  • The border can be painted in Bambu Studio (use the Tool type “Fill” with “Edge detection”)
    • Use a different color to create a subtle or bold accent
    • Use the same color as the base to make the border disappear
      • This will also remove the prime tower which is recommended to keep when printing with more than one color.
• Customizable Logo (optional)
  • It´s possible to add an SVG File as Logo for the Mousepad. Just add and SVG to the bottom, merge it and then paint the SVG.
  • Please be aware: a logo could confuse the mouse laser. This is not the case without a logo.
• Scalable for any printer
  • The mousepad can be resized to fit any build plate:
    • Disable “Uniform Scale” in your slicer in the scaling view
    • Adjust X and Y dimensions to your desired size
    • Keep the thickness unchanged for best results

Important Printing Notes

• For best results, a textured PEI build plate is highly recommended. 
  • It provides the best surface finish.
• Ensure the build plate is clean to guarantee proper adhesion. 
  • Poor adhesion may cause the edges to lift during printing.
• Do not remove the mousepad while it is still warm.
  • Wait until the print has fully cooled down before removing it from the build plate. This helps maintain a clean surface finish and prevents bending.
• You should watch the Printer as it lays down the first layer. Sometimes those printers fling poop on the plate during the initial wipe. That could ruin the surface.
• I would suggest to use PLA which detaches from the plate the easiest after the print is done. 

Additional Info

Slippery desk surface

Depending on you desks surface a printed Mousepad can be somewhat slippery. I thought about adding round recesses for TPU Feet but that would make resizing in the slicer more complicated. What i would suggest:

• i am using this and can recommend it: https://www.amazon.de/dp/B0G5K32JS9?ref=ppx_yo2ov_dt_b_fed_asin_title - its thin and holds the mousepad in place very well.

If you like this print i would appreciate a 5-Star rating and/or a Boost. Thank you!