Cat Stairs
Print Profile(2)
Bill of Materials
- Super Glue x 1: For Affixing The Parts Together
Description
Description
A functional set of stairs to assist elderly cats, and small dogs. The model consists of 4 steps, 2 bottom stair brackets, 2 top stair brackets, 1 left square bracket, 1 right square bracket, and two stiffening rods. I haven't fully tested it's load capacity, but It handles my 20lb cat without issues.
Printing
For a uniform finish I would try using a smooth PEI build plate on the supports, and textured for the steps. Your mileage may vary however, as I do not currently own any smooth PEI plates. The hexagon pattern is made by using slicer modifiers to expose the sparse infill, make sure “Reduce Infill Retraction” is off to prevent stringing.
Size
The Model is 18" or 45cm tall, 17.5" or 44cm deep, and 9.75" or 25cm wide. Each piece is just barely small enough to fit on an A1's 256x256 build volume.
Assembly
Superglue is recommended to affix all the pieces together in a sturdy configuration. The pegs are merely there for alignment, they don't provide anything structurally.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (3)