Surf Wave
Print Profile(1)
Description
Surf's Up, Dude!
This is a fun surfing simulator for all ages, try it out with one of the boards I have designed, small boats, finger surfboards or whatever else you might fancy.
It has a hose connector for the Gardena system integrated, so all you have to do is connect the hose.
Size: 252 x 176 x 69 mm
Printing
- 0.2 mm layer
- Tree supports
- 15% Gyroid infill
- AMS ready with two colors
- Tested and printed in PLA
- I recommend using PETG as support interface if printing in PLA
The water pressure could affect the wave, and if you are experiencing low pressure then you can tilt it a bit for the wave to be a bit more “downhill”. Water tend's to collect inside the model, so don't store it on your favorite furniture after use ;-)
Boost Me (for free)
I hope you enjoy my work and a boost goes a long way in keeping me busy designing and testing new models :-)
Membership
Do you want to support my work or sell prints of my models? Commercial license for my models are available here on MakerWorld.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (33)