Modern Clock (Clock Component Kit)

• Here is my design for modern clock. They are made for kit-011, but it will propably take any random clock mechanism.

Here is a link for the kit: https://eu.store.bambulab.com/collections/makers-supply/products/clock-components-kit-011

Everything was designed in Inventor. Avery part is provided in .stl and .ipt

• Building

Take PLATE and you clock mechanism. Put on rubber and vasher and on top of this put PLATE, then put on nut, but don't tighten it yet. There should be hole on the back side of PLATE. That hole should be pointing up, then batery on a clock mechanism pointing down. Now take BASE and remove supports from the holes. Slide your assambly from previos step to a BASE. You will need to line hole with a pin. Now take the FRAME and again remove supports. Line up FRAME and BASE with slight angle, that pins on FRAME will go to the holes in BASE. Now twist FRAME clockvise. Take your clock arms. Hour and second arm must be shortened by 11mm to fit. Put them on and you are almost done. Only thing that is left is the PIN. It can be used to corect time by putting it to the hole on backside of BASE and then as decorative element in the front.

For more details check video: 

• Also I might redesign PIN, Because it is a bit short. It still works for both uses, but when you are setting up time, it wants to skip a hole sometimes.

Hope you like it and wish you sucesfull prints!!

• Also sorry for my Engilsh. It isn't my nativ language :)