Search models, users, collections, and posts
Microlab - Height Extender
Remixed by
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
3.7 h
2 plates
Open in Bambu Studio
Boost
24
50
3
1
56
19
ReleasedĀ
Description
Extend the height of your Microlab 3D printable server rack with this modular upgrade.
Two versions are included:
š¹ Single Pillar Extenders (x4 needed) ā cost-efficient, minimal filament use.
š¹ One-Piece Frame Extender (x1) ā cleaner look,stronger, prints in one part.
Designed to be screwed in with M3x12 bolts ā no nuts required. Tight fit tolerances ensure stability without extra hardware.
Keep in mind that only 1 of the versions is needed to extend the height of the Microlab.
Includes:
- Height Extender ā Single Pillar (4x needed)
- Height Extender ā Full Frame (1x needed)
Comment & Rating (3)