need to be very careful with support settings as they can be very difficult to remove.

The two halves were off in a couple of ways and it made me wonder if there was an error in the print, but it does seem to be an issue with them aligning correctly.

On a reprint I would downsize it slightly, but that’s my fault for not first measuring how much straw was above the lid on my daughters cup.

This has an awkwardly long tail giving it a very lizard-like appearance. On a reprint I would remove a section or two of the tail.

Need to cut the little parts within the trigger mechanism to get it to work properly. I am not sure if just playing with the tolerance would fix it, but once you cut it it works well!