seam location is really unfortunate (although my settings for this filament are bad), it should be manually moved to more discrete location

nice, small improvement would be to hide the seam with a scarf seam

printed in overture glow in the dark pla, it's a bit translucent so should have added some top layers as infill structure is visible in some places (will also increase the glow), maybe I'll have to print another 😁

great way to spend that old brittle filament. printed in pla and adults can walk on it without issue

seems good

perfect, thanks!

great

it's nicer to use

simple but works great

great, but this and most (all?) designs makes it impossible to flip ams internals for removing clogs

it's just great

the door is very flimsy and I'm not sure I would trust it to not spill dessicant everywhere, ended up printing the one with no door

dropped it once from about 1m and it already cracked, printed again with 4 walls and 15% gyroid, it feels stronger but I'm still a bit worried. I printed in pla since I have plenty of brittle pla to waste, petg would probably be a better choice

unfortunately too weak at the bottom where it meets the base plate, printed them with solid bottom using a modifier and now seems to hold up

used it on sand, for grass i think it's easier to bury with some new grass

the spring didn't work for long unfortunately, maybe because i used silk pla

i find printing them on their side to produce stronger nails. also made the top part solid to withstand hammer better

a lot of supports but pretty easy to remove, looks good

very good, just wish the lid had a bit bigger lip for easier opening

printed it without support and it came out perfect, the supports are annoying to remove as they are sandwiched in the narrow hole so I find this much better. otherwise great, used black bambu matt pla but still a bit shiny due to the textured pei plate (and geeetech red is way too dark..), white and red are shiny on the original also so for those works great.