Emi_Fisa

Games

Practical

Beautiful figure! Clearly thought for more for filament printing than resin. I printed it with the standard settings (except for Z hop when I lost the tail on the first attempt when one of the supports failed). I think the top of the head could do with a little more height from the plate. I’ll probably try that next but at a thicker layer height (these 2 were printed at 0.08 High Quality standard setting and took like 8hs each).

蓝三一

动漫猫咪女孩 支撑易拆

Anime Cat Girl Easy-to-remove supports

100mm高版 0.2mm 层高, 2 层墙, 15% 填充

100mm tall version 0.2mm layer height, 2 walls, 15% infill

This design is so good!! I’ve printed it all in opaque colours and it works PERFECTLY as cable ducting!:)

Growler

Daiseychain LED Strip Light Track 

0.2mm layer, 2 walls, 15% infill

Great quality and the supports are a bliss!!!

AU3D

IKEA Skadis Container D60 H25

All Sizes | 0.2mm layer, 2 walls, 15% infill

A little bit of post processing required to remove the wisps of filament (maybe under-retraction). but other than that it looks perfect:)