scaled to 125%

The detail is incredible and as expected exercise caution removing supports especially the tail area I also glued mine down but not necessary

it’s not perfect but a fun easy project nonetheless

needed a ramp for the SCX24 so I scaled it to max plate and turned out perfect for my needs

only downside is the micro towel has to be fully covered or the outside ring will not seat properly and scratch the bed

perfect for a scx24

nice setup

border collie is on the far left found it odd he printed on his tail but it came out great

certainly a conversation piece simple to assemble and a joy

so cute only bad part was the bottom of the heart it’s holding didn’t form hardly noticeable unles pointed out

very nice

awesome!!! one of my favorite prints

fit like a glove a little tight going on but that was expected for proper function

So cool I even made a cursed d20 that rolls mostly 1’s

looks amazing much nicer than expected

waiting for the lights but simply love this project. ok so the name wouldn’t light up because there was a layer of black on the inside and I couldn’t figure out how to keep it pink I’m sure there’s a way I just couldn’t figure it out but I’m learning and only been at it since Christmas less then 3 weeks ago so what I did was after the 3rd layer I swapped out the black for clear and it turned out perfect this time here’s a before and after photo of both with the lights on.

turned out better then expected so nice I’m going to make a second one.

grandkids will love this