looks amazing. Just wish I'd followed the assembly instructions properly as had to strip it down completely as put together in wrong orientation 🫣

safe to say the little guide is pretty much spot on. 25hr print and no more red silk left but decided to send it as the guide said so 👍

been a nightmare (through my own fault) finally getting it installed but worth the effort. works really well and no more floppy tubes

one of my favourite prints so far. The "leather" texture looks amazing

got there in the end 😁👍 I've the got SM00 model with 01 blades. I'm new to this so have no idea how to upload the print dimensions I've used hence the photo. it's a nice snug fit 👌

needed to make some adjustments with the Dremel as apparently the UK model is slightly different. still works perfectly well though 👍

lovely print, shame it's not suitable for the io9

rubbed some grease on plate to prevent filiment sticking

tried a few and this is by far the best. nice angle and not too close resulting in blurred image