I saw so many people enjoying the first version I thought I would also share this second version I created which has sharper knife edges on each tip as well as a sharpened point on the back side of the support arm.

My wife likes reading and she likes volleyball, So…

I created this years ago and published it on Thingiverse, but I wanted to bring in over to Maker World, so here it is!

I made this larger version of my original that kept the tight tolerances needed for a successful print in place design.

I made this years ago, but since I got my Bambu I wanted to bring it over to Maker World Lots of downloads and positive comments from Thingiverse so I know many people have printed and used it, even commercially.

I was impressed by @ondrej.vesely89's original design, but like @Lazy_Lu I wanted the funnel to tip down to take the strain off the filament as it entered the funnel. unfortunately Lazy_Lu's design needed supports under everything, wasn't angled down enough for when the spool was nearly empty and didn't support a PTFE connector (suggested by @Erga) I would have referenced Lazy_Lu's design, but it wasn't marked to allow remixes, so all my work was based off of @ondrej.vesely89's design.