NEW AND IMPROVED - Han Solo Blaster Wall Mount. This is a 2-color wall mount for HPonstein's Han Solo Blaster Model, which can be found on Thingiverse. The struts have been reinforced to hold a much denser version of this gun. Additionally, the leveling of the gun has been greatly increased to ensure it sits perfectly level on your wall. The screw caps have been made deeper and tighter so they simply snap in - no glue needed. ENJOY!

Do you have an under-the-counter light that is just a little too sensitive, and goes off all the time, and not quite how you want it to? This motion sensor screen can help limit indirect changes in light - so that motion sensor only works when you want it to!

Do you have a shut-off value that is tricky to reach? Do you wrench on the faucet handle only for the spigots to break? Use this handy spigot faucet wrench to turn the tap easily without the danger of breaking the handle. The special head is designed, to put equal pressure on each spigot to allow for more pressure spread out over the full area of the handle. The easy-to-turn handle fits in the palm of your hand.

Han Solo Blaster Wall Mount. This is a wall mount for HPonstein's Han Solo Blaster Model, which can be found on Thingiverse. It is currently set up as a 2-color print, but feel free to modify it as you wish. It was originally designed for the Bambu A1 with AMS. I am an avid Star Wars fan, so I am releasing this content with permission to be shared and commercially sold if desired for all you Star Wars lovers!

This is a replacement dust duct for the Superior SCMS10L Miter Saw. Bolts and washers are reused from the machine. It may be compatible with some other miter saws with some minor adjustments. Happy to accommodate you if you need help in that area.

This is a replacement dust duct for the Superior SCMS10L Miter Saw. Bolts and washers are reused from the machine. It may be compatible with some other miter saws with some minor adjustments. Happy to accommodate you if you need help in that area.

Ever have challenges getting magnetic latches to sit just in the right place? Use this simple jig and its sliding columns to get the placement just right before locking those latches down permanently with the two bored-out center holes. Remove the tediousness of drilling a million holes and still not getting it just right. Slightly tighten the sliding columns and adjust as needed—then bolt it down when you have the distance just right!

Do you have a shut-off value that is tricky to reach? Do you wrench on the faucet handle only for the spigots to break? Use this handy spigot faucet wrench to turn the tap easily without the danger of breaking the handle. The special head is designed, to put equal pressure on each spigot to allow for more pressure spread out over the full area of the handle. The easy-to-turn handle fits in the palm of your hand.

There are some times when a bracket is truly needed and cannot be hidden. So make it look good! A simple and elegant 90 degree bracket for just such an occasion.

Prevent your A1 printer from drifting out of place with these stabilization brackets. Very helpful when printing anything with significant height. Just add some 2-sided tape to the bottom or adhesive and lock that baby down! If you share - please credit. Much appreciated.