I needed a simple, reliable device riser that I could print quickly without wasting time on complicated supports or multi‑part assemblies. Nothing I found quite matched what I wanted—clean lines, stable angle, easy print, and a design that just works right off the plate. So I made my own. This tablet riser is built around the idea of practical simplicity: a single-piece print, minimal supports, and a comfortable viewing angle that fits almost any setup. Have fun!

Honestly, I got bored, and when I'm bored, I hop on Makerworld. What else to make this?

This model is built to be easy for anyone to print, even on beginner setups. It’s small, clean, and functional — perfect for organizing your desk without using a lot of filament. If you like practical prints that just work, this one fits right in!