Easy print with AMS. Used bambu basic black and bronze. Nice office desk prop. Yes, it is mounted a bit tilted here. :-)

Launcher printed beautifully in wood-PLA. Using Bronze for the gears. Used a bit of Vaseline-based lubricant for smooth operation.

Bambu Bronze PLA surface and generic white PLA below. My slicer did show a third colour but couldn't really figure out if that was needed, so i merged to two and it came out great. Be warned, your partner will hate you for fiddling with this :')

flawless print. bit tight on the microSD slots (due to the notch they may go in a bit tilted) but it works well enough.

the rollers are extremely prone to tipping over. (at least on the H2D in petg). I would recommend to add a brim and set the rollers close together so that the brims touch eachother as well.

fits perfectly in AMS2, even when lid is closed. I had one that broke on me when i applied to much force when snapping it on the spool. I recommend aligning the holes in the cardboard (to thread filament for storage) to the left and right. Then add the label side to the top, connect the bottom and then make it fit around the perimeter.