Great design and easy print. Thanks!

Printed 2 of these, one for my office at work and one for a friend. Great design and easy print. Thanks!

Great design and fairly easy print. I printed it in Bambu Lab blue and black PETG-CF. It turned out nice. Thanks!

Great design & easy print. It looks great in my office at work. Thanks!

Great design & easy print. It looks nice in my office at work. Thanks!

print was very easy. Printed in ASA. The parts did not fit the bike, however.

Very nice design & easy print. I made it as a gift for a friend who loves dad jokes. Thanks!

great design & easy to print. First time printing with 5 colors. Thank you!

Good and easy print. Very fast. Thanks

Easy print - turned out very nice in red Bambu PLA Basic. Thanks!

Great design and easy print! Be careful when screwing them together - do not overtighten them or the threads will snap off. I super glued them together to make them permanent. Printed in Bambu Lab black PLA.

Perfect print and design. Thanks!

Very nice design and print! I have a 2022 R1250GS Adventure and it needs an oil change. I made this out of Bambu Lab black PETG-CF. Thank you! Finally did the oil change and the funnel worked perfectly. Thank you very much!

Printed perfectly in gray Bambu Lab PLA. Thank you!

printed perfectly. Thanks!

Printed this back in November, 2025, and forgot to rate it. Print was very long (as expected) but turned out very nice in black PLA and red PLA for the drawers and accents. I have this on top of my P1S and I’ve been printing and drying ASA filament. This has caused the PLA to sag a bit such that one of the drawers will no longer pull out. I am now in the process of calibrating the PETG-CF that I’m going to try and reprint it in. I highly recommend this model, but do not make the same mistake I did and print it in PLA.

Printed well in TPU for AMS. Fit perfectly around my Pack Talk Pro. Thanks!

Printed well in gray Polymaker ASA. I printed the feet with TPU for AMS and it also printed well, but the tabs broke off easily when trying to insert them. I pulled all of them off and just super-glued them to the riser. That worked just fine. Thanks!

Excellent design, perfect print, and great installation instructions! Thank you! Now, I need some cord management…

Printed great in blue translucent PETG for the first set I printed. Had it installed and working fine but one of the parts broke during use, so I decided to reprint it in gray ASA. When I installed the gray set, none of the four would feed the filament into the ASM 2 Pro. I removed all of them and started reading through the comments to see if others were having filament loading issues. I found a comment from @Kuyodie who said if the filament will not feed, then it is installed incorrectly. He discovered that the part that snaps in place around the filament inlet was getting in the way of the loading push tab. So, I tried reinstalling them and watching how the lower part was installed relative to the filament inlet. You have to make sure the front of the bottom piece is UNDER the filament inlet. I recommend setting the lower bracket into place but not snapping it in until you verify the filament inlet tab moves freely. Now, it works like a charm! See photos… Thanks!