Love it, works like a charm! It really does suck up more dust than the original, also helps keep the sander more flat as opposed to tilting it by mistake. Just make sure to remove all the inner supports from the ridge otherwise the two halves wont fully seat on the sander.

Printed very nice, I just quickly used a wooden 8mm dowel instead. Its a bit small but I needed it that way, if youre using bambu studio you can even elongate it/stretch it if need be.

Already using it, maybe I shouldve printed in PETG-HF because it does/can wobble a bit so you have to be very gentle when striking a line or it might be angular.

awesome print, been using them for two three weeks now and bumped one a few times. didnt crack or move at all. placing them close together was an oopsie because the clips interfered with each other but I just screwed one to the other side and its a non issue now. sturdy enough for sure!

been hanging for about two weeks and its solid! I used it a few times, can be a bit cumbersome to remove it from the cleat and the blade did tend to fall out. I just used some tape on the inside of the inside as a spacer and now the blade fits snug.

good print, they work on these random Duro chisels. There is one issue, they tend to wobble and can fall out if im not careful so I should've made the tolerances tighter or the dip for the heads bigger but Im still a rookie at this so not fully sure how i would've done that without having to redesign everything from scratch.

very nice! I've been using them for about 2-3 weeks and they're holding up. bumped one a few times (by mistake) and nothing moved or cracked. I love the click into the battery as well.

Awesome print, haven't really put them to work yet. Just tested them and seem sturdy enough, dont know on big glue ups though but small ones they should work perfect.

I love the design aince I have an aluminium cheap one from ali/temu that is off at the screw part so they dont fit very well together when making 90° lines. This one solved that issue because its printed in one go. Sadly the measurements stick out by 1mm it seems (dont know if thats my printer or by design). Im still a rookie when it comes to printing so it could very well be my fault. In the grand scheme of things it wouldn't matter but for real precision the numbers lift the angle a bit up and that could tilt the measurement out of 90°.

Love it, was struggling a lot with where to put my pliers and this worked really well. It even fits on my shitty non 45 degree angled french cleat and it's sturdy! The holes only fit smaller thinner legged pliers. Chunky ones not so much but they would hold the weight most likely.

Made several of these in different colours for my girlfriend. Do watch out for bleeding colours if youre going from dark to light. We found out a bit late but still use our blackish pink octopus :)

Awesome print, I like the fact it's pretty light and reassembly is possible so you can even take it on trips with you and you most likely won't get stopped because it's not made out of metal etc. Thanks designer!

I only printed the loose angled one. It is loose but not too much, I did find it a bit shallow for the bits but for me it really doesn't matter since I'm not using/moving this piece that often but if you are, maybe make the depth the bits sit in a bit deeper :) No pic momentarily