Went very big on this, taking advantage of the H2C's size. Red PLA translucent.

Very nice. Made for my daughter. Make sure you print the test pieces FIRST.

I think you need to bump up the walls from 2-4 to add some rigidity to this model, but a solid start.

Fantastic, except the lettering which goes into the cap. You have to rotate the logo forward, so that supports release easier. Also, you need to use either support material or PETG (for PLA). Either way, it's ALOT of waste into the prime tower to print just the logo on the cap. I would change it and would rather spend a bit more time printing the cap, but change the negative space to a modifier, and color it.....Also, rotating the cap forward a bit, gives you better supports so that it does not break off during the print, as the brim which it prints with by default is not enough to hold it to the plate. Great model though...

Boosted

Fantastic design

Loved this design, and print.

this printed very well

Beautiful....fits like a glove.

Worked great.

Worked great.

These are tricky to print, especially when you start getting into the thin walled filaments. Description should list something which suggests to print these on a smooth plate, with glue, and then use water to wash them off. Otherwise they potentially tear when moving them. Even had to resort to putting them in the freezer to get them off the PEI plate cleanly...

Used the smaller by 1% and worked great

Great print, no issues

would have loved a bigger, more ergonomic handle

Worked out well

Supports were an issue. . . but overall, nice print.

Good design

Fantastic model. Boosted.

This design is so simple, yet functional. 5 stars and boosted