perfect print!

I’ve printed a couple of these so I could have one at work and at home.

My wife doubts it but she likes the print.

supports are difficult to remove and there are a few rough spots but over all these are great models. my daughter and wife loved them!

Beautiful model. A little difficult getting the support material off the face.

what could be butter than these earring?!?

I only printed the one that was slightly scaled up. works great.

Prints great love that it’s dual sided

prints great

I did have some print failures but I think it was my fault because I was trying too hard to limit supports. the model itself is great and gets lots of laughs.

my son loves it!

I updated your design to hang toast tongs on my toaster!

my wife loved it!

fits perfect. printed in ASA so I can dry pellets without removing them.

Great print in ASA. can be a little tricky to install without going in too deep. as long as you follow the instructions and use the hook it works great.

printed in ASA to prevent softening

My grandson loves this.

love it

This is great. Printing it to give to all my military friends.

great little top spins well