I have printed a lot of these satisfying loud whistles and handed them to every friend who walks anywhere alone after dark. In the photo, I scribbled a friend's name on it for a personal touch!

Fun whirling noise without sending anyone to the ENT. Printed several color combos as work - gifts, went over really well! Photos: 1) Bambu Stars Effect Plate in Bambu Hot Pink and Jade White PLA 2) Bambu Carbon Fiber Effect Plate in Bambu Black and Red PLA

My Arabian Drone Flute (in Bambu Rose Gold Silk PLA) next to my triple Arabian Flute (in Amolen Coffee Gold Silk PLA). Sounds as beautiful as it looks. The joints could be tighter, but a little teflon tape fixed the problem. My long term solution will be to just glue the joints together to ensure a tight seal.

Beautiful flute with a haunting sound, shown in Amolen Coffee Gold Silk PLA. There were zero printing issues. The joints are a little loose (cheap silk filament - but I adore the color), so I added some teflon tape at the joints and it fixed it. Though if you are not planning on constantly disassembling your flute, I would just glue it.

Absolutely my favorite toolbox by far! There is something so satisfying about having every piece slot into a precise slot. I do like having angled slots for the lubricants but there are enough Compartments on this one to take care of them, plus other spare parts and screws. Like another user, my new, unused hotend fell out of the slot, so I printed the tops for the hotends, which also promptly fell out. The measurements are spot-on, I think it is a shrinkage after printing. I increased JUST the width of the hot and lids to 101.5% and they fit perfectly. They are super fast prints, so try one at 101% and gradually increase to fit.

all of your butterflies are amazing!

just adorable!

great model, hat was a nightmare - after two bundles of fiber (it would get about 1cm up and then just disintegrate, silk filament stored at ~15% humidity - I also tried a plain black Bambu PLA in case it was the fault of the generic pink/gold silk - no luck). I finally rotated it and put it on its brim and printed it on a smooth plate. That worked, however, it is super thin and has multiple raised places on the top. But it turned out alright at the end. I took a star off for all of the work put into reprinting the hat, but the design is 🌟🌟🌟🌟🌟.

printed perfectly!

printed beautifully - some supports on hair difficult to remove, but overall great!

printed perfectly! Great way to store the collection of swatches from the BAMBU Store.

cute and printed very well in black, white, and maroon on silver PLA

nicely done, can only put something very thin inside or it will snap.

adorable - printed a few for gifts for a coworker

printed very well - made a collection of these and other pet paperclips for my husband's desk

printed very well, made a collection of these and other pet paperclip for my husband's desk

I left a detailed comment before - great item. Easy to print and easy to tweak a little to make it personal!

Great stuff - only problem I had was with the sunglasses. The app generated P1S supports cutting holes in the lenses. I changed the print face so no more supports touching the lens and all good. Amazing job, keep creating!

I gave a detailed post before.