very effective so far

it's the single colour grey, printed out fast and works great!

great print!

great little print, my silk filament is older so the layer had a small issue but I don't think that's related to the print profile.

good overall profile, the top surface is a bit rough but I'm not sure if that's an issue on my side or not. everything else is great! printed in black petg, marble pla for the chicken

looks really good considering how small the model is. printed with a .4 nozzle and looks fantastic. some of the overhangs look like they didn't fully slice due to wall sizing, if I were to print it again I would change to a different wall generator. potential to do a variable layer height for the top layer to smooth out the stepping or even adjust which face it's printed on for finer details. overall amazing print for the time and materials. added Canadian quarter for scale

No modifications made, was able to use it in a no name vacuum. the brim was very difficult to remove and if I print it again I would attempt it without. slowing down the speed to ensure bed adhesion

cat did not approve but I do. added a small square & negative part to allow it to work for my 17.5mm coffee table legs. took a lot of work to get the balls free using petg. found it was easier to freeze them, then the initial crack was easier.

printed out great, I really like the way it looks but it doesn't hold the bottom two parts tightly. I would have preferred a snug fit, however no parts have fallen out.

This is the coolest 3d print to keep on-hand and show off how intricate 3d printing has gotten. I've easily given away 10+ of them so far, and then showed them how I can just print another one right from the app. I would love to try and get this printed in metal.

Works well! Printed it in black PETG. Will post a remix of it attached to the coffee table