Sunlu Ams dryer Knob. 3m Tape on back. If you don't want the stripe you can erase [painting in bambu studio. ALso, for a faster print, you have the option to turn off adaptive layer height. If you prefer not to have the BL logo, split into objects in studio too. Anyway, here ya go!

Charmp (75 ft/sec model) waist fan louver. They are the strongest fans I have found on Amazon. They work great but I wanted to have the option to direct the wind as needed. Standard 0.20, gyroid infill 15%, normal supports seem to work the best for this.

This is a great neck ac but it tends to loosen up if you are working or walking/bending down. This fits into the joint on the back to keep it tight. The little handle goes on top and is used to remove it. You can gently squeeze the ends together to install and remove this. It will not over stress the joint or cause any damage to the device if properly used.

The original cover was very well made. I thought I would make an extension to extend it to the back of the panda mount. I am new to 3D printing. I've only had my printer for about a month so im sorry I do not know how to join the two together yet but I will figure that out and update asap. Thank you for the models. This site is great!