Search models, users, collections, and posts
Share
0
0
0
Thank you for the model! It turned out awesome. I added a couple of other colors to the color and cheeks. Tolerances could have been a little tighter but nothing some super glue couldn't solve lol :-D
Share
0
0
0
Absolutely awesome model! Print profile was great. This is exactly what I needed and it holds a lot of games in a small amount of room. Boosted twice 😀
Share
0
0
0
These things are amazing! They screw together so smoothly and hold a lot of dessicant. I've printed 10 of these so far and put one in each of my spools. It dropped my RH in my AMS down to 10%! Thank you!
Share
0
0
0
Awesome build, thanks so much! I printed with PLA matte and it turned out great. The bearing fit perfectly and it rotates nice and smooth. I printed another one in PETG, reduced it by 50% and used a smaller bearing. Still turned out great!
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
It turned out awesome!! All the tools fit perfectly for my P1S. Thank you!
Share
0
0
0
It turned out great! Thank you! It gets stuck in the holder but that's only because of how tight the plug is so you just have to wiggle it out a little bit.
Share
0
0
0
I printed one then it came out so awesome I printed another one! Thank you!
Share
0
0
0
Share
0
0
0
It's exactly what I needed thank you so much! The only issue I'm having is that about half of the cartridges fall out every time I close the lid. The funny thing is if you flip the cards around they stay in perfectly but I don't want to flip them all over to find the game I want to play haha. I only read of one other person having this issue so far. I printed it with Bambu PLA matte filament on my P1S with your profile. Maybe it's something I did.
Share
0
0
0
So cute! I printed two of them and they turned out awesome, thanks!
Share
0
0
0
Share
0
0
0
Share
0
0
0
This is a great design! It printed so well with PLA matte yellow! thank you!
Share
0
0
0